#USB 485 CONVERTER FULL#

This converter is with built-in zero delay auto receiving and transmitting conversion and unique I/O circuit auto control data flow direction without any handshake signal (RTS, DTR) there is no need jumper wire setting for full duplex (RS-422) and half duplex (RS-485) mode, plug & play. RS-485/422 adopts terminal block as connector. This voltage restraint provides 600W each wire with lightning, ESD protection, and surge voltage, instant overvoltage protection on circuit which causing by all reasons the tiny interelectrode capacitance ensures high speed transmission for RS-422/485 ports. The built-in fast instant voltage restraint is designed to protect RS-422/RS-485 interface it adopts advanced TVS (TRANSIENT VOLTAGE SUPPRESSOR) instant voltage restraint normally, TVS tube is in high impedance state when both sides of TVS tube suffer from high power impact in a sudden, the voltage restraint will fast lower the impedance from both sides, and absorb in big current with this, the voltage on both sides are fixed at presupposed value, protects the component of circuit from damage. It complies with USB, RS422, and RS-485 standards it converts USB signal to a balanced differential RS-422 or RS-485 signal. UT-885 is a universal USB to RS-485/422 converter, there is no need of external power supply. Transmission media: Twisted-pair or shielded cable.LEDs for indicating PWR TXD, and RXD activity.

Connector: USB-A male, RS-485/422 5-pin terminal block.Port protection: 600W lightning, surge, ± 15KV ESD protection.Transmission distance: 1,200m(9,600bps) for RS-485/422, no more than 5m for USB.Loading capacity: Supports point to multi-point communication, allows to connect 32 sets RS-422 or RS-485 device.

#USB 485 CONVERTER SERIAL#

Baud rate: 300-921.6Kbps auto-detect serial signal.

Direction control: Adopts traffic direction auto control technology.

Working mode: Asynchronous, point to point or point to multi-point, 2 wires half-duplex or 4 wires full-duplex.

Usb 485 converter